The difference between Deadbreak Connectors and Loadbreak Connectors

You can know every new products be published here, and witness our growth and innovation.

The difference between Deadbreak Connectors and Loadbreak Connectors

Date:09-06-2021

The difference between Deadbreak Connectors and Loadbreak Connectors

Application

● Realize the connection of single-phase or three-phase insulated cables and transformers, switch cabinets, branch boxes and other equipment through 630A prefabricated connectors.

● Suitable for indoor and outdoor installation.

● Maximum system voltage 24kV

● Continuous rated current 630A (900A overload can last 8 hours)

● Cable characteristics

 

-Polymer insulation (XLPE, ERP, etc.)

-Copper or aluminum conductor -Has semi-conductive or metal shield -Conductor size: 12kV 25-400mm2    24kV 25-400mm2

 

■ Performance

● When matched with a suitable casing or plug, a fully shielded and fully sealed separable connection is provided;

● It can be operated under water and other terible conditions for a long time;

● The built-in capacitance test point is used to determine the live state of the line and must be used in conjunction with a live display;

● There is no minimum safety distance requirement between phases;

● The installation can be vertical, horizontal or any angle.

 

Installation

● No need for any special tools, straps or padding;

● After the cable connector is installed to the relevant component, it is energized and operated immediately;

● Provide conventional assembly parts and installation instructions.

Product structure:

1. Stud bolts: stainless steel bolts ensure that the conductor and the casing are closely matched.

2. Insulation layer: The unique formula and mixing technology ensure the high quality of prefabricated EPDM insulating rubber.

3. Insulator: The epoxy resin insulator contains threaded metal parts to ensure a close fit with the studs.

4. Capacitance test point: Capacitance test point is used to test whether the circuit is live.

5. Test point cover: The prefabricated EPDM conductive test point cover protects the test point and grounds it during normal operation.

6. Inner semi-conductive layer: prefabricated EPDM conductive rubber can effectively control electrical stress.

7. Adaptor: Stress cones of different sizes are used with cable joints to ensure water sealing and cable stress release.

8. Grounding eye: pre-injected into the outer shield for the connection of the grounding wire.

9. Simi-conductive Shield: the prefabricated EPDM conductive rubber is overlapped with the cable shielding layer to make the shield continuous, and to ensure that the outer semi-conductive layer is in a grounded state.

10. Conductor Cable Lug: all-copper or copper-aluminum crimp terminals are suitable for copper or aluminum conductors.

 

Standard Packaging:

European front connector body

● Insulator (including semi-conductive cap)

● Dust cap (non-insulating protective cap)

● Stress cone

● Crimp terminal

● Stud bolt

● Silicone grease, cleaning paper

● Installation instructions

● Product qualification certificate

● 3pcs/box